AGXV Automatic HVLP Spray Gun
Devilbiss AGXV Automatic Spray Gun (source: ITW Industrial Finishing)
Devilbiss AGXV Automatic Spray Gun
Item No.: AGXV-540, AGXV-541, AGXV-542 & AGXV-543
AGXV – V stands for the HVLP version of AGX gun
540 – for common finishing materials waterborne and chlorinated.
541 – for high solids coatings which are difficult to atomize with HVLP
542 - for waterborne and other corrosive materials
543 - for high solids coatings which are also corrosive
Fluid Tip/Nozzle
Range: 0.8-2.2mm
0.8mm G (AV-2115-G / AGX-4402-G)
1.1mm FX (AV-2115-FX / AGX-4402-FX)
1.1mm FX (AV-2120-FX / AGX-4600-FX) in combination with 46MP air cap
1.4mm FF (AV-2115-FF / AGX-4402-FF)
1.4mm FF (AV-2120-FF / AGX-4600-FF) in combination with 46MP air cap
1.8mm E (AV-2115-E / AGX-4402-E)
1.8mm E (AV-2120-E / AGX-4483-E) in combination with 83MP air cap
2.2mm D (AV-2120-D / AGX-4483-D) in combination with 83MP air cap
Air Cap
Atomization Technique: HVLP (High Volume Low Pressure)
Air consumption: n/a
Air Cap Selection Guide: see chart
| Air Cap No. | Order No. | Typical Application | Spray Pattern |
| 33A | JGHV-101-33A | common finishing materials (360cc/min) | 229mm long, tapered ends |
| 46MP | JGHV-101-46MP | low VOC materials (360-480cc/min) | 280mm long, straight sided |
| 83MP | JGHV-101-83MP | low VOC materials (510cc/min and above | 330mm long, straight sided |
Misc.
Weight: 738g (without mounting stud)
Maximum Recommended Working Pressures
Inlet Pressure (max.): 100 PSI (7 bar)
Fluid Pressure (max.): 100 psi (7 bar)
Cylinder Air Pressure
– Min. **50 psi (3.5 bar)
– Max. 100 psi (7 bar)
Hose Connections
Fluid Inlet: 3/8″ NPS(M)
Cylinder Air: 1/4″ NPS(M)
Atomization Air: 1/4″ NPS(M)
Features
This Devilbiss AGXV automatic spray gun is designed for use with robots, automatic machines and stationary mountings. It is a further development of the AGX automatic spray gun, i.e. the spray head has been modified to provide maximum transfer efficiency by limiting air cap pressure to 10 psi (0.7 bar), i.e. it is a HVLP gun. The spray head is also detachable for a fast needle packing replacement. A special feature are the PTFE (teflon) needle packings which are spring loaded for extended service life. And for more abrasive coatings, abrasive fluid packing are available as an option. This gun may be used with chlorinated solvents. Aluminum is not used in fluid passages. If using chlorinated solvents, make sure all other fluid handling components are also compatible.
Applications
General purpose solvent based and waterborne coating materials,including chlorinated solvents.
Service Manual
AGXV Operation Manual (Source: ITW Industrial Finishing)
Competitor Products
n/a
